About Product:
Brand New AS-250-150 X-Axis Power Feed Kit is for Bridgeport and Similar Knee Type Milling Machines.
The machine is used for X axis,if you want to used for Y axis,a SUPPORT PLATE will be needed.These will fit almost any vertical knee type mill out there with the 5/8" Shaft End, Including but not limited to Bridgeport, Precision Matthews, Grizzly, Enco, Jet, Sharp, Acer, Webb, GMC, Kent, Clark, Supermax, Enco, Turn Pro, Vectrax, Acra, Birmingham, Accu, First...etc. The gear ratio between transmission plastic gear and motor shaft gear is not a whole number. The two gears will not mesh and wear at the same spot, this not only increases durability and longevity but even reduces noise over time.
Warning
1. Be sure to follow the procedure for jog operation to avoid any damage caused by wrong movement.
2. Make sure the power feed stops before you change the direction.
3. The switch should be in the "OFF" position when the machine is not in use or before plugging.
Maintenance
1. Gear cover must be open every 6 month to check whether lubrication for spiral gear is sufficient. Graphite type lubrication is suggested rather than silicon type.
2. Carbon brush cap should be open every 6 month to check if the brush has wore out. Brush should be replace immediately if its length is under 5mm (front and back brush should be replaced together).
Features:
Speed adjust knob.Speed can be adjust according to operator’s requirement, ranging from 0-9.
Jog switch.Normally, jog switch should be at “FEED” position. For jog movement, just switch to "0" position. Kept holding the switch until it travels to requires position.
Brand new
X-axis power feed for Bridgeport type milling machines
Reversible and auto shut-off at end of cut
150 Lbs. torque
Variable speeds
Longer lifespan
Effortless operation
Limit switch for sensitive stop
No loss of dial or hand crank
Noiseless direction changes
Better surface smoothness
Small volume and easy installation
Excellent speed control in the entire range
Power table feed won't vibrate or strain in low speed
Direction control knob for easy and rapid operation
Safety feature to protect transmission gear and electronic components
Specification:
Type : X-axis
Model : AS-250-150
Voltage : 110 V, 60 Hz
Torque : 150 lbs
Rotate speed : 0-200 rpm
Length : 33 cm (13 inch)
Width : 20 cm (7.9 inch)
Height : 18 cm (7 inch)
Gross weight : 6.5 kg(14.3 lb)
Package Includes
1 x AS-250-150 X-Axis Power Feed for Milling Machine
1 x Set of Necessary Accessories
1 x Product Manual
Note:
If you have any questions about this product, I hope you will contact us as soon as possible. We will serve you wholeheartedly
Product Details:
