Fill out my online form.
NanoVNA-H PCB Upgrade
Features added after the update:
1. Lower power supply noise, less noise when using harmonics;
2. Built-in 400mAh battery
3. Add a MicroSD card to save the test data;
4. Add RTC support;
5. Modify the port names to Port1 and Port2
MicroSD supports up to 32GB, and only supports SPI mode.
This is a DIY product that provides as complete a vector network measurement capability as possible on a credit card sized dimension. It includes a 2.8-inch touch screen, 400mAh battery, TX/RX measurement, and can measure complete S11 and S21 parameters. If you need to obtain S12 and S22, you need to manually replace the transceiver port wiring.
● PCB: 54mm x 85.5mm x 11mm (without connectors and switches)
● Measurement frequency: 50KHz ~ 1.5GHz
● RF output: -13dbm (maximum -9dbm)
● Frequency accuracy: <2ppm
● Frequency stability: <0.5ppm
● Measuring range: ● Measuring range: 70dB(50kHz-300MHz),(50dB(300M-900MHz), 40dB(900M-1500MHz));
● Port SWR: < 1.1
● Display: 2.8 inch TFT (320 x240)
● USB Interface: USB type-C Communication Mode: CDC (Serial)
● Power supply: USB 5V 120mA, built-in 400mAh battery, maximum charging current 1A, can be used continuously for more than 4 hours
● Number of calibration points: 101 (fixed)
● Number of scan points: 101 (fixed)
● Display Tracks: 4, Markers: 4, Settings Save: 5
Measure S-parameters, VSWR, phase, delay, Smith chart...;
1. NanoVNA host*1 (including 2.8-inch touch screen, 400mAh battery)
2. 20cm SMA male to male RG174 RF cable *2
3. SMA female to female connector *1
4. SMA Simple Calibration Kit SHORT *1
5. SMA Simple Calibration Kit OPEN *1
6. SMA Simple Calibration Kit LOAD *1
7. USB Type-C data cable *1
8. Touch pen*1
9. Picks